I have a 88 pathfinder and i would like to lift the front end. i already lifted the rear end almost 3" with ford coils and RS5000s. so far for the front i have RS5000s and sway away torsion bars. I've read somethings about the AC upper control arms not being the right length. so i am thinking about buying a set of Superlift UCA. just looking for some opinions here.

thanks

Checo has a set.


1998 Frontier 4x4 with ALL the goodies!
2002 Xterra 4x4 still stock
Grow the Nissan Community and stand up for ORV user rights!

I had them on my '90 Hardbody for about 2 years until I sold it. Never had a problem with them.

Yes I do! They work very well. They also seem a lot tougher than the AC ones IMHO.

I first bought the AC ones from a buddy and they were way to short. They were shorter than the stock ones. The only thing they did was correct the ball joint angle.

Go with SuperLift! They are worth the extra $$


"Even if you are on the right track, you'll get run over if you just sit there." - Words of Wisdom

good deal guys i guess i'll be going with the superlifts then. i found them on summit for $239.95. should i get a pair of low profile bump stops too?

Couldn't hurt.


1998 Frontier 4x4 with ALL the goodies!
2002 Xterra 4x4 still stock
Grow the Nissan Community and stand up for ORV user rights!

I had a set on my 93 pathy and they were great. I had a bad experience with the ac ones, so I payed the extra for the superlift ones. You cant go wrong.

I installed mine just last week. Believe it or not this is my third set of aftermarket UCAs. First Rancho, then AC and now Superlift. The AC arms were way to short and I had to shim the heck out of them to get a proper alignment (8 washers on each spindle bolt ) which ment longer spindle bolts were needed. The Superlift are great but the bushing sleeves were too long so I reused my old ones.