My clutch in making horrible screeching noise every now on then. I am thinking it is the throw out bearing?

Has anyone done a clutch on 2nd generation?
I have only done them on 1st generations?

Any good shops in the Denver or Colorado Springs area? I will probably do it myself unless shops are cheap.

Thanks

Richard Eddy
97 Pathfinder SE 5spd
Castle Rock, CO

Did you ever change your clutch?? I did a writeup on my site...

Barry
96 Pathfinder SE 4x4 5 spd- AC 2"lift and AC polys
94 Quest GXE

I have not gotten to it yet. It has not been making as much noise lately, so I have put if off until I have to do it. When I get it done I will send you some pictures.

R

Richard Eddy
97 Pathfinder SE 5spd
Castle Rock, CO

I for got to lube my input shaft and I get a little noise when cold occasionally. But the bearing noise is gone..

Barry
96 Pathfinder SE 4x4 5 spd- AC 2"lift and AC polys
94 Quest GXE

The pilot bushing is the probable cause. Real easy to replace.

Yeah its the pilot bushing. I have 2 new ones. I bought a special pilot bushing puller, but its too dam big.. I recently swapped my clutch/pplate/ tbearing.. I just forgot to put a little grease on the pilot bushing.

Barry
96 Pathfinder SE 4x4 5 spd- AC 2"lift and AC polys
94 Quest GXE
TNT Member http://texasnissantrucks.com/