Written by Mikey Soo

Tools Required
• 8mm wrench
• Phillips head screw driver

Difficulty of Installation
Not hard at all.
It took me about 10 minutes. (might have been faster if I had set out the tools right away) I changed my cap and rotor at my Apt. complex under the covered parking.

Removal/Disassembly
• Remove new distributor cap from box. Compare to current cap to check for accuracy in product.
• Label all plug wires or find a way to remember which are which.
• Remove plug wires from distributor cap.
• Using Phillips head screw driver, loosen two Phillips head screws on distributor cap.
• Remove cap.
• Compare new rotor with old to check accuracy in product.
• Using 8mm wrench or ratchet, remove small screw on distributor rotor. (screw is not on top, but rather on side of rotor.)
• Remove rotor.

Installation
• Install new rotor.
• Replace small screw on side of rotor using 8mm wrench. Do not overtighten.
• Install new distributor cap.
• Making sure cap is tight against distributor assembly, tighten the 2 screws which hold down the cap using a Phillips head screw driver.
• Replace spark plug wires in correct places. (this should be easy if you labeled them during removal)

I also disconnected my battery before starting this procedure. I did this to reset the computer's memory for the new cap and rotor.