Hey, I was wondering if anybody knows right off hand what the correct headlight aiming specs are, or maybe where to find them? I turn them on and I can tell that they are both pionting diff directions...

[un]Stuck In Alaska,
Ian

Move to a level surface. Place a marker at 300 inches from the front of the vehicle. Measure the center height of the lamps. The top edge of the beam should be at the same height 300 in. out, and slightly aimed to the right with a 42 in. spread between the two beam centers.

Ricochet


Negotiating "Mother" on Hite's Cove Trail.
Photo: H. Ballard

'96 HB-XE KC M/T 4wd.
Mods: Hella Headlights, KC Reverse Lights (So that's what's back there. Glad I didn't run over that!)

if you want a very accurate reading gotta have it on flat surface, with tires properly inflated and a half of tank of gas...

i thought that the reflection of the low-beams should be 2 inches lower than the line across the wall...

have been wrong before though, too

FYI: Full run down of this procedure, along with a diagram was just posted here on XF ironically enough, relating to another thread.

Hope this helps...