Recent Posts New Posts Tools Board Menu
    Nissan4wheelers.com Forum    Nissan4wheelers.com Forum  Hop To Forum Categories  Shade Tree Mechanic    Frontier rear brake line
Page 1 2 
Go
New
Find
Notify
Tools
Reply
  
-star Rating Rate It!  Login/Join 
Administrator
N4W Card Holder



Ultimate N4Wheeler
Picture of Desert Rat
Posted
The 24" braided line I have is officially too short.

I need a 27" one.

It's been so long since I replaced it and I can't really tell just by looking, but are both ends of the soft line a male end?

What's the Nissan brakeline thread pitch again? I think it's a 10x1, but I don't remember.



1998 Frontier 4x4, 2002 Xterra 4x4, and Z28 street rocket
Pass here and go on. You're on the road to heaven - Kerouac
 
Posts: 22112 | Location: Home of the AZ runs | Registered: June 22, 2002Reply With QuoteEdit or Delete MessageReport This Post
Ultimate N4Wheeler
Picture of hillbille
Posted Hide Post
smiley34M10 x 1.0


.....................
"Climate change is no longer science. It's politics... Climate change is also about power. Power to control.... It's about who gets to decide: how much energy we will have... where that energy will come from... what it will cost... It's about simulations, scenarios and monsters conjured up by computer models that should never be used to chart government policy -- especially on matters that will profoundly affect our livelihoods, living standards, life spans and dreams of a better future.

"So hold onto your wallets, and hope you can hold onto your homes, cars and jobs. You're about to be put on a wild political roller coaster."

- Paul Driessen, TownHall.com ( the lies of global warming)>

http://www.youtube.com/watch?v=-zeGY8zbzc8
 
Posts: 7273 | Location: enron by the sea,ca | Registered: July 03, 2002Reply With QuoteEdit or Delete MessageReport This Post
Administrator
N4W Card Holder



Ultimate N4Wheeler
Picture of Desert Rat
Posted Hide Post
So uh....male ends on both ends?



1998 Frontier 4x4, 2002 Xterra 4x4, and Z28 street rocket
Pass here and go on. You're on the road to heaven - Kerouac
 
Posts: 22112 | Location: Home of the AZ runs | Registered: June 22, 2002Reply With QuoteEdit or Delete MessageReport This Post
N4W Card Holder

Off-Road Warrior
Picture of gumybob
Posted Hide Post
Andy, I need one too, so when your ready to get one, can you get two? I can get you the money before or after.

Just placed my H233b under my truck, thought the top connection was female, then the bottom is the T block with the two connections to the hardline. Am I thinking of the same line or a different line.

Bob


---------------------------------------------------------



04 SAS Frontier, 8" Lift Total, 35x12.5x15 MT's with Staun Internal Beadlockers, Calmini Crawler Gears, ARB Front & Rear Air Lockers.
 
Posts: 1342 | Location: Gilbert Az. | Registered: October 26, 2005Reply With QuoteEdit or Delete MessageReport This Post
Administrator
N4W Card Holder



Ultimate N4Wheeler
Picture of Desert Rat
Posted Hide Post
No, you might be right on that.

I'll check into two.



1998 Frontier 4x4, 2002 Xterra 4x4, and Z28 street rocket
Pass here and go on. You're on the road to heaven - Kerouac
 
Posts: 22112 | Location: Home of the AZ runs | Registered: June 22, 2002Reply With QuoteEdit or Delete MessageReport This Post
N4W Card Holder

Off-Road Warrior
Picture of gumybob
Posted Hide Post
Top connection at the clip is female, then the T Block has 2 female connection to the hardlines with the one bolt hole to the mounting bracket.


---------------------------------------------------------



04 SAS Frontier, 8" Lift Total, 35x12.5x15 MT's with Staun Internal Beadlockers, Calmini Crawler Gears, ARB Front & Rear Air Lockers.
 
Posts: 1342 | Location: Gilbert Az. | Registered: October 26, 2005Reply With QuoteEdit or Delete MessageReport This Post
Pavement Pounder
Posted Hide Post
when i bought my 27 incher from AC, top was female block and bottom was male


99' V6 fronty

skids-suspension-lights-rims/tires-otherstuff
 
Posts: 35 | Registered: March 01, 2008Reply With QuoteEdit or Delete MessageReport This Post
Administrator
N4W Card Holder



Ultimate N4Wheeler
Picture of Desert Rat
Posted Hide Post
Thanks



1998 Frontier 4x4, 2002 Xterra 4x4, and Z28 street rocket
Pass here and go on. You're on the road to heaven - Kerouac
 
Posts: 22112 | Location: Home of the AZ runs | Registered: June 22, 2002Reply With QuoteEdit or Delete MessageReport This Post
N4W Card Holder

Off-Road Warrior
Picture of gumybob
Posted Hide Post
Did you look at yours? From that I saw, the hose was attached to the T block, didn't look like you cold unscrew it.


---------------------------------------------------------



04 SAS Frontier, 8" Lift Total, 35x12.5x15 MT's with Staun Internal Beadlockers, Calmini Crawler Gears, ARB Front & Rear Air Lockers.
 
Posts: 1342 | Location: Gilbert Az. | Registered: October 26, 2005Reply With QuoteEdit or Delete MessageReport This Post
Administrator
N4W Card Holder



Ultimate N4Wheeler
Picture of Desert Rat
Posted Hide Post
I'll have to get under it.



1998 Frontier 4x4, 2002 Xterra 4x4, and Z28 street rocket
Pass here and go on. You're on the road to heaven - Kerouac
 
Posts: 22112 | Location: Home of the AZ runs | Registered: June 22, 2002Reply With QuoteEdit or Delete MessageReport This Post
Administrator
N4W Card Holder



Ultimate N4Wheeler
Picture of Desert Rat
Posted Hide Post
Gumy, AC has the bolt in replacement, but it's expensive.

27" thingy

Still want to go forward?



1998 Frontier 4x4, 2002 Xterra 4x4, and Z28 street rocket
Pass here and go on. You're on the road to heaven - Kerouac
 
Posts: 22112 | Location: Home of the AZ runs | Registered: June 22, 2002Reply With QuoteEdit or Delete MessageReport This Post
N4W Card Holder

Off-Road Warrior
Picture of gumybob
Posted Hide Post
Hey,... I won a $50 Gift Cert at GoneMOAB for 4x4parts.com. I know what I can use it on now. Thanks for the link, I will order my own.

Andy, do you want me to order 2 to save on shipping?


---------------------------------------------------------



04 SAS Frontier, 8" Lift Total, 35x12.5x15 MT's with Staun Internal Beadlockers, Calmini Crawler Gears, ARB Front & Rear Air Lockers.
 
Posts: 1342 | Location: Gilbert Az. | Registered: October 26, 2005Reply With QuoteEdit or Delete MessageReport This Post
NISSAN4WHEELER
Picture of LordBiotree
Posted Hide Post
OK, The rear brake line fittings are all female. I will be ordering one soon also.

There's a local place in jax which manufactured D.O.T approved brake lines. I'm going with them, probably be about half the coat of a/c. The brake hose is only like $5-7 a foot. The brake fittings are expensive because of brass prices


1995 KC XE-V6 4x4.
 
Posts: 4598 | Location: U.S.A,Tallahassee/Jacksonville, Florida | Registered: June 17, 2003Reply With QuoteEdit or Delete MessageReport This Post
NISSAN4WHEELER
Picture of LordBiotree
Posted Hide Post
I have another question.

How long are the stock front brake lines?


1995 KC XE-V6 4x4.
 
Posts: 4598 | Location: U.S.A,Tallahassee/Jacksonville, Florida | Registered: June 17, 2003Reply With QuoteEdit or Delete MessageReport This Post
Wheeler
Picture of lmhin
Posted Hide Post
I am thinking you could check with Sumit Racing Earls perfomance brake stuff


SAS'ed and locked

smiley22
 
Posts: 148 | Location: Rowlett Tx | Registered: May 03, 2005Reply With QuoteEdit or Delete MessageReport This Post
 Previous Topic | Next Topic powered by eve community Page 1 2  
 

    Nissan4wheelers.com Forum    Nissan4wheelers.com Forum  Hop To Forum Categories  Shade Tree Mechanic    Frontier rear brake line

© Nissan4wheelers.com 2002
Copying/Reproduction of any information or Photographs/Images Prohibited without prior written permission from the Administrator

N4W follows the Tread Lightly philisophy and asks that members do the same.
Let's keep our trails open!
For more information on Tread Lightly, visit their website!