hey guys im looking at making some uca's with a spherical ball joint like this http://www.sdhqoffroad.com/store/fab-unib.asp but cant find the housing it goes into anyone know where i can find the housing for that ?
Posts: 484 | Location: chandler | Registered: August 05, 2007
you could just find a piece of thick wall tubing that has an inner diameter the same as the outside diameter of the uniball and press it in. weld a collar to the top to stop it from going all the way through. Weld on your hoops for your control arm and your done.
89 Nissan Pathfinder, 4" trailmaster Suspension lift, 1.5" rear lift coils, Rancho 9000x all round, 3" body lift, sway-away torsion bars, big stereo, rebuilt and transplanted hauss engine and trans. 33x12.50 bfg mud shoes on 15x10 polished aluminum wheels. makin room for 35s
That would also work if you had a Mill to bore out the part to accept the uniball. For DIY fab work they sell pre-milled parts to weld in where you need them.
Brent 1972 K5 Blazer
Posts: 1327 | Location: Chandler | Registered: September 29, 2005
N4W follows the Tread Lightly philisophy and asks that members do the same. Let's keep our trails open! For more information on Tread Lightly, visit their website!
90, HB, SE, 4x4, 3"SL, 32's, Warns, and stuff 
